Resources What's New Support Download Contact Sales: Arthur-Industrial@outlook.com
Home › Resources › Sampling and the central limit theorem

Sampling and the central limit theorem

Populations vs samples, random sampling, standard error, and why averages behave normally.

We almost never measure every part. We measure a sample and use it to estimate the population (all parts the process makes, or will make).

Good samples

  • Random: every unit has the same chance of being chosen.
  • Representative: covers all shifts, machines, cavities and lots that matter.
  • Large enough: enough units to estimate what you need with useful precision.
  • In SPC, samples are taken in rational subgroups over time rather than at random, on purpose (see that article).

Standard error

The standard deviation of a sample mean. It shrinks as the sample grows, but only with the square root of n: four times the data halves the uncertainty.

The central limit theorem

For most distributions, the mean of n independent values is close to normally distributed when n is moderately large, with mean and standard deviation . Subgroup averages of 4 or 5 already look fairly normal unless the underlying data are very skewed. This is why Xbar charts are robust to non-normal data.

Sampling bias to avoid

  • Measuring only the first parts after setup.
  • Letting the operator choose "good-looking" parts.
  • Sampling only on day shift.
  • Dropping parts that were reworked.

Questions and answers

How many parts should I measure?

It depends on the decision. For a control chart, collect at least 20 to 25 subgroups before setting limits. For capability, at least 100 values over representative conditions. For comparing two processes, use a sample size calculation.

Is a bigger sample always better?

Bigger samples give more precise estimates, but measuring 1,000 parts from one hour tells you little about next week. Spread samples over time and conditions.

← All articles