Resources What's New Support Download Contact Sales: Arthur-Industrial@outlook.com
Home › Resources › Short-run, multivariate and other special charts

Short-run, multivariate and other special charts

DNOM and standardized charts for many part numbers, Hotelling T² for related characteristics, and pre-control.

Short-run charts

Job shops run many part numbers in small lots, so no single part number has enough data for its own chart.

  • DNOM (deviation from nominal): plot each measurement minus its own nominal. Works when the part numbers have similar variation.
  • Standardized (Z) charts: plot for each part number. Works when variation differs between part numbers.

Charts follow the machine or process, not the part number.

Multivariate charts

When characteristics are related (length and width of a stamped part, temperature and pressure), separate charts can miss unusual combinations. Hotelling's T² chart combines them into one statistic using their correlation. When it signals, look at which variables contributed.

Three-way (between/within) charts

When there is a natural, stable difference between subgroups (for example, positions on a wafer), the I-MR-R/S chart charts the subgroup means with individuals limits and the within-subgroup spread separately.

Pre-control

A simple method based on the tolerance, not the process data. The middle half of the tolerance is green, the outer quarters yellow, and outside the tolerance red. Rules such as "two yellows in a row: adjust" decide when to run or stop. Pre-control is easy for operators but is not a control chart: it does not show whether the process is stable and works only when the process is already capable.

Questions and answers

Our machine runs 40 part numbers a week. Can we still use SPC?

Yes. Use DNOM or standardized charts per machine and feature type, and record the part number with each point.

In RS-1: SPC > Short Run, Hotelling T² and Pre-Control.

← All articles